Table of Contents
Advertisement
Fig 24
Checking both sides of the table are level
Step 5 Replace the table insert by lining up the two pins
in the insert with the machined holes in the recess to the
centre of the cast iron table. Push firmly down, see figs
25-26.
Fig 25-26
Insert pin
Machined hole
Table recess
Fence Assembly
Locate the front fence rail with scale (4), rear fence guide
rail (5), fence (6), fence clamp assembly (7), M8 lift & shift
handle (8), M8 threaded lever (9), threaded 'T' slot insert
(10), M6x20mm bolts (11), M6x16mm bolts (12), M8 large
washer (13), M6 small washers (14), spring washers (15)
and M8 nut (16).
Step 1 Place a washer (14) over each M6x20mm bolt (12),
line up the elongated holes in the front fence rail (4) with
the pre-drilled holes to the front of the cast iron table
(1), introduce the two M6x20mm bolts (12) through the
fence rail and lightly tighten using the supplied spanner
(22), see figs 27-28-29-30.
11
11
14
Step 2 Place a spring washer (15) over each M6 caphead
screw (12), line up the holes in the rear fence guide rail (5)
with the threaded holes to the opposite side of the cast
iron table and secure in place with the two M6 caphead
screws (12) and using a 5mm Hex key tighten the guide
rail, see figs 31-32-33-34.
15
11
Main Assembly
Fig27-28-29-30
4
14
Spanner
12
5
Continues Over....
Fig 31
Advertisement
Table of Contents
