Table of Contents
Advertisement
Setting Up the Saw
Fig 70-71
Thrust bearing
Loosen the Hex screw (A) holding the guide bearings
and move to approximately 0.5mm from each side of
the blade. NOTE: A sheet of A4 of photocopy paper is
approximately 0.5mm thick. Adjust the guide bearings
by turning the adjusting Hex screw (B), until the bearings
are set to the correct thickness. Re-tighten the Hex screw
(A), see fig 72-73-74.
Gently push the blade back against the thrust bearing,
use a scrap of wood and check that the side bearings are
still behind the teeth of the blade.
Fig 72
D
2mm behind the blade
Blade
A
B
Guide bearings set to 0.5 thickness to the blade
Setting the Blade Guides (below table)
IT MAY BE EASIER TO SET THE GUIDE BEARINGS
IF THE CAST IRON TABLE (1) IS REMOVED, REFER
TO MAIN ASSEMBLY INSTRUCTIONS.
Remove the guide bearing guards and place safely aside,
see fig 75.
Beneath the table loosen the butterfly screw (C) holding
the lower blade guide assembly in place and position so
that the leading edges of the side guide bearings are
approximately 2mm behind the gullets of the saw blade.
Re-tighten the butterfly screw (C), see fig 76-77.
Note: The guide bearing should always be set behind
the teeth of the saw.
Bearing guard
24
Fig 73-74
Fig 75
Advertisement
Table of Contents
