Intermediate Transfer Unit - Canon imagePRESS C1 P Service Manual

Chapter 7
FRONT

7.14.24 Intermediate Transfer Unit

7.14.24.1 Preparation for Removing the Intermediate
Transfer Unit
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Detach the process unit cover.
3) Lift the hopper unit.
4) Remove the primary charging assembly. (page 7-86)Reference [Re-
moving the Primary Corona Assembly]
5) Remove the pre-transfer charging assembly. (page 7-88)Reference [Re-
moving the pre-transfer corona assembly]
6) Remove the drum unit. (page 7-89)Reference [Removing the Drum
Unit]
7) Pull out the fixing/feeding unit.
7.14.24.2 Removing the Intermediate Transfer Unit
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the high voltage connector cover [1].
2) Disconnect the 3 connectors [1].
3) Free the 2 harnesses [1] from the harness guide [2].
4) Remove the ITB fan duct cover unit [3].
- 2 screws [4]
7-100
REAR
F-7-202
[1]
F-7-203
[1]
[1]
F-7-204
[4]
[2]
[3]
5) Remove the ITB drive unit [1].
- 5 connectors [2]
- 4 screws [3]
0014-0074
[3]
[2]
[3]
6) Remove the intermediate transfer unit [1].
0014-0075
- 1 connector [2]
- 1 screw [3]
[2]
[3]
Points to Note When Mounting the Intermediate Transfer Unit
Make sure to move in the direction of the arrow with the intermediate trans-
fer unit [2] on the rail [1] of the host machine.
[4]
[1]
F-7-205
[2]
[2]
[2]
[3]
[1]
F-7-206
[1]
F-7-207