Siemens SIMATIC ET 200pro Manual page 73

Testing mechanical environmental conditions
The table below provides information about the type and scope of mechanical environmental
condition tests.
Condition tested
Vibrations
Shock
Continuous shock
ET 200pro distributed I/O EtherNet/IP interface module
Manual, 03/2016, A5E32861915-AB
Test standard Interface, electronic, and connection modules;
Pneumatic interface modules with FESTO valve terminals
Vibration test accord- Type of vibration: Frequency sweeps with a rate of change of
ing to IEC 60068-2-6 1 octave/minute.
5 Hz ≤ f ≤ 12 Hz, constant amplitude 15 mm
12 Hz ≤ f ≤ 150 Hz, constant acceleration 10 g
Duration of vibration: 10 frequency sweeps per axis in each of three
perpendicular axes
Shock, tested accord- Type of shock: half-sine
ing to IEC 60068-2-27
Shock intensity: 30 g peak value, 18 ms duration
Direction of shock: 3 shock tests in +/- direction in each of the
3 perpendicular axes
Shock, tested accord- Type of shock: half-sine
ing to IEC 60068-29
Shock intensity: 25 g peak value, 6 ms duration
Direction of shock: 1000 shock tests in +/- direction at each of the
3 perpendicular axes
General technical specifications
6.4 Mechanical and climatic environmental conditions
73