Siemens SIMATIC ET 200pro Manual page 47

Attribute
ID
When Adapter Object AutoConfig attribute is true: These attributes reflect the nonvolatile configu-
1
ration parameters and are not used by the Adapter.
When an I/O connection is open, setting this attribute returns Device_State_Conflict.
2
Attribute 5 [SlotStatus] details
The SlotStatus attribute, listed in the table below, reports the operating status of the module
installed:
Status code
0
1
2
3
4 - 255
Attribute 6-13 [Channel<n>Status] details
The Channel<n>Status attributes, listed in the following table, report the operating status of
each channel in the module:
Status code
1
2
3
4
5
6
7
8
9
16
17
18
19
20
21
22
23
24
25
26
ET 200pro distributed I/O EtherNet/IP interface module
Manual, 03/2016, A5E32861915-AB
Access rule Name
Text
OK
Module error
Wrong module
No module
Text
Short circuit
Under voltage
Over voltage
Overload
Excess temperature
Wire break
Over range
Under range
Internal module error
Parameter assignment error
Sensor or load voltage missing
Fuse defect
Communication error
Ground error
Reference channel error
Process interrupt lost
Actuator warning
Actuator shutoff
Fail-safe shutoff
External error
The ET 200pro EtherNet/IP module
3.8 Device profile: vendor-specific objects
Data type Data value
Description
Module is operating normally.
Slot is empty - no module installed.
Reserved
47