When A Normal Hdd Is Mounted - Toshiba e-STUDIO477S Service Manual

•

When a normal HDD is mounted

HDD Assist Mode
Current HDD type: SATA HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
Remarks:
• If the HDD type cannot be identified, "Unknown HDD" may appear on the screen.
Refer to  P. 5-56 " [F106_1] ADI-HDD error: HDD type detection error"
Notes:
• When "SATA HDD" (normal HDD) is displayed, items 1 and 2 are not selectable.
• If you select any of 1 and 2 and press the [START] button, the error message below appears.
HDD Assist Mode
Current HDD type: SATA HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
=>
2. Remove key
Operation Failed.
Press SoftPower Key to Switch Off
e-STUDIO477S/527S/477SL
SELF-DIAGNOSTIC MODE
System Firmware Version
Update Mode
Fig. 3-8
System Firmware Version
Update Mode
Fig. 3-9
© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
3 - 20
: xxxx(x.x.x.x)
: 4c Mode
: xxxx(x.x.x.x)
: 4c Mode