Smtp Address Unset; Server Time-Out Error; Smtp Server Connection Error; Terminal Mail Address Error - Toshiba e-STUDIO477S Service Manual

[1C65] SMTP address unset
Reset the SMTP address and perform the job.
Turn the power OFF and then back ON. Perform the job in error again.
[1C66] Server time-out error
Check if the SMTP server is operating properly.
[1C69] SMTP server connection error
Reset the login name or password of SMTP server and perform the job again.
Check if the SMTP server is operating properly.
[1C6B] Terminal mail address error
Check the SMTP Authentication method.
Check if there is an illegal character in the Terminal mail address.
Set the correct SMTP Authentication method or delete the illegal character and reset the
appropriate Terminal mail address, then perform the job again.
[1C6C] Destination mail address error
Check if there is an illegal character in the Destination mail address.
Delete the illegal character and reset the appropriate Destination mail address, then perform the job
again.
[1C6D] System error
Turn the power OFF and then back ON. Perform the job in error again.
If the error still occurs, replace the SYS board.
[1C70] SMTP client OFF
Set the SMTP valid and perform the job again.
[1C71] SMTP authentication error
Check that SMTP authentication method, login name and password are correct, then perform
authentication again.
[1C72] POP Before SMTP error
Check that both the POP Before SMTP setting and POP3 setting are correct, then perform
authentication again.
[1CC1] Power failure
Check if the power cable is connected properly and it is inserted securely.
Check if the power voltage is unstable.
[ 2 ] RFC related error
[2500] HOST NAME error (RFC: 500) / Destination mail address error (RFC: 500) / Terminal mail
address error (RFC: 500)
[2501] HOST NAME error (RFC: 501) / Destination mail address error (RFC: 501) / Terminal mail
address error (RFC: 501)
Check if the Terminal mail address and Destination mail address are correct.
Check if the mail server is operating properly.
Turn the power OFF and then back ON. Perform the job in error again.
[2503] Destination mail address error (RFC: 503)
[2504] HOST NAME error (RFC: 504)
[2551] Destination mail address error (RFC: 551)
Check if the mail server is operating properly.
Turn the power OFF and then back ON. Perform the job in error again.
If the error still occurs, replace the SYS board.
© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
5 - 73
e-STUDIO477S/527S/477SL
5