5.3
Diagnosis and Prescription for Each Error Code
5.3.1
Check item
Check item
Sensor check
Connector check
Harness check
Motor check
Board check
e-STUDIO477S/527S/477SL
ERROR CODE AND TROUBLESHOOTING
•
Check the sensor in the test mode.
•
Check that there is no dust on the sensor.
•
Check that the actuator is correctly operated.
•
Check that the connector is not disconnected.
•
Check that the pins are not deformed and do not come off.
•
Disconnect and reconnect the connector.
•
Check if the harnesses are open circuited.
•
Check the motor in the test mode.
•
Check that there is no abnormality in the driving section.
•
Check that there is no abnormality in the roller.
•
Check if the board is short circuited or open circuited.
5 - 28
Contents
© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved