Appendix 9
Follow the precautions below when connecting the MELSEC iQ-R series module as a local station in a system where the
master station is the module other than MELSEC iQ-R series.
• Use any of the following modules for the master station.
Model name
QJ71GF11-T2
LJ71GF11-T2
Q81BD-J71GF11-T2
QS0J71GF11-T2
• If the first 5 digits of the serial number of the master station is smaller than the number shown above, set "RX/RY Setting" in
"Network Configuration Settings" to any of the following.
Action
Set the largest end number in all stations to multiples of 32 - 1 by
changing the number of cyclic assignment points or adding the reserved
station.
Reduce the largest end number in all stations to 7FH or less.
APPX
380
Appendix 9 Precautions for When Connecting the Module to the Conventional Product
Precautions for When Connecting the
Module to the Conventional Product
Example
• Before change
• After change
• Before change
• After change
First 5 digits of the serial number
"16012" or later
"16012" or later
"16012" or later
"16022" or later