Chapter 2 Parameter Settings; Setting Parameters; Required Settings - Mitsubishi Electric MELSEC iQ-RJ71EN71 User Manual

2
PARAMETER SETTINGS
This chapter describes the parameter settings required for communications between the master/local module and other
stations.
2.1

Setting Parameters

1.
Add the master/local module in the engineering tool.
[Navigation window]  [Parameter]  [Module Information]  Right-click  [Add New Module]
2.
The required settings, basic settings, and application settings are included in the parameter settings. Select one of the
settings from the tree on the window shown below.
[Navigation window]  [Parameter]  [Module Information]  Target Module
3.
After setting parameters, click the [Apply] button.
4.
Write the settings to the CPU module using the engineering tool.
[Online]  [Write to PLC]
5.
The settings are reflected by resetting the CPU module or powering off and on the system.
2.2

Required Settings

Set the station type, network number, or other parameters for the master/local module.
2 PARAMETER SETTINGS
124
2.1 Setting Parameters