Gas Connection; Fitting A Stability Bracket - Rangemaster 110 User's Manual & Installation Instructions

front of the cooker is supported on the feet, not the
front roller, to prevent accidental movement of the
cooker.
Leave the levelling tool on the adjuster with the
handle of the tool facing the rear of the cooker,
so that the customer can use it if they wish to
move the cooker.
Replace the drawer by locating on side runners and
push in.

Fitting a stability bracket

A stability bracket or chain (not supplied by with
the cooker) should be fitted when the cooker is
connected to a flexible gas supply.
When fitting a stability bracket read these
instructions together with the leaflet supplied with
the bracket.
1. Place the cooker in its intended position and
level the cooker.
2. Draw a pencil line 100mm from the front edge of
the levelling feet.
3. Mark the centre line for the bracket by
measuring 550mm from the left hand side of the
cooker.
4. Lower the front roller and move the cooker
forward.
5. Measure back from the pencil line 550mm to
locate the front edge of the bracket. Fix the
bracket to the floor.
6. Measure the height from floor level to
engagement edge in back of cooker. Add 3mm to
this dimension and assemble the stability bracket
to this height. (i.e. from floor level to underside
of the top member) and ensure the bracket does
not foul anything

Gas Connection

The Gas supply needs to terminate with a down
facing bayonet. The rear cover boxes limit the
position of the supply point.
Because the height of the cooker can be adjusted
and each connection is different it is difficult to give
precise dimensions. Ideally the house supply
bayonet should be in the shaded area shown in the
diagram. Although a 900mm hose can be used, a
1250mm hose will allow slightly more flexibility in
the positioning of the bayonet and make moving the
cooker easier. The hose should be fitted so that both
inlet and outlet connections are vertical so that the
hose hangs downwards.
The connector is located just below the hotplate
level at the rear of the cooker.
The connection hose must be suitable for the gas
and pressures used and conform to the appropriate
standards. If in doubt contact, your supplier.
Screw the threaded end of the hose into the gas inlet
in the underside of the connector block on the back
of the cooker.
After completing the gas connection, check the
cooker is gas sound with a pressure test. When
checking for gas leaks do not use washing up liquid -
this can corrode. Use a product specifically
manufactured for leak detection.
Pressure Testing
The gas pressure can be measured at one of the
hotplate burner injectors. Lift off a burner head. Fit
the pressure gauge to the injector. Turn on the
hotplate burner and turn on and light the grill
burner.
26