Minute Tour - Rangemaster 110 User's Manual & Installation Instructions

2 Minute Tour

Be safe
You need clean fresh air - so does your cooker. Burner flames produce exhaust gases, heat and
moisture. Make sure that the kitchen is well ventilated: keep natural ventilation holes open or install a
powered cooker hood that vents outside. If you have several burners on or use the cooker for a long
time, open a window or turn on an extractor fan. For more detail see the Installation Instructions.
We recommend you read page 18 if you have not used a gas cooker before. We describe some basic
guidelines on how to use a gas cooker safely.
Gas and Electricity on
Make sure that the gas supply is turned on and that the electricity supply is connected and switched
on. The cooker needs electricity.
Peculiar smells
When you first use your cooker it may give off a slight odour. This should stop after a little use.
Hotplate Burners
Some models have a glass lid
over the hotplate. If it is not
open, lift it up at the front.
There is a safety device that cuts off
the gas to the hotplate when the
lid is closed - but don't use this to
turn the burners off.
Adjust the flame height to suit
by turning the knob. On this
cooker the low position is
beyond high, not between high
and off. The small flame marks the
'low position'. Turn the knob
towards it after the contents of a
pan have boiled.
More about the burners on page 8
The drawing by each knob
indicates which burner that
knob controls.
The smaller burners are for
smaller pans and simmering.
Make sure flames are under
the pans. Using a lid will help the
contents boil more quickly. Pans
and kettles with concave bases or
down turned base rims should not
be used. Avoid using unstable and
misshapen pans that may tilt easily
and pans with a very small base
diameter. The minimum pan
diameter recommended is 120mm
(about 4 3 / ").
4
2 Minute Tour continues over the page...
3
Push in and turn a knob to the
large flame symbol ( ) and
press the igniter button or
light with a match.
Simmering aids, such as
asbestos or mesh mats, are
NOT recommended. They will
reduce burner performance and
could damage the pan supports.