Moving The Cooker - Rangemaster 110 User's Manual & Installation Instructions

Moving the Cooker

The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker.
Ensure that the floor covering is firmly fixed, or
removed to prevent it being disturbed when moving
the cooker around. You will need the levelling tool.
From the back tilt the cooker forward and remove
the rear half of the polystyrene base pack.
Repeat from the front and remove the front half of
the poly base. Pull the drawer out to its furthest
point. Lift it up and out.
Fit the levelling tool on the rectangular adjuster as
shown below.
LOWER THE FRONT ROLLER by doing 14 complete
(360º) turns clockwise. (This means turning and
removing the levelling tool 56 times).
Now LOWER THE TWO REAR ROLLERS.
First fit the levelling tool on the hexagonal adjusting
nut as shown below.
Make 10 complete (360º) turns clockwise. (This
means turning and removing the levelling tool 20
times).
Make sure you lower BOTH REAR ROLLERS. There
are two adjusting nuts, one for each roller, at both
the front bottom corners of the cooker.
Unfold the rear edge of pack base tray. Carefully
push the cooker backwards close to its final position
leaving just enough space to get behind it. Take care
not to damage the power cable.
Do not use the door handles or control knobs to
manoeuvre the cooker. Remove the pack base tray.
Levelling
You are recommended to use a spirit level on a shelf
in one of the ovens to check for level.
Place the cooker in its intended position taking care
not to twist it within the gap between the kitchen
units as damage may occur to the cooker or the
units.
The rollers can be adjusted to level the cooker. To
adjust the height of the rear of the cooker use the
levelling tool supplied to turn the adjusting nuts at
the front bottom corners of the cooker.
Adjust the height of the front roller to level the
cooker. Turn clockwise to raise the cooker and
anticlockwise to lower.
When you are satisfied with the height and level
raise the front of the cooker by one turn of the front
roller adjuster. Screw down the front feet to meet
the floor. Screw the front roller adjuster
anticlockwise to raise the front roller so that the
25