Setting Green Ethernet Properties For Ports - Cisco 200 Series Administration Manual

Port Management
Green Ethernet
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business 200 Series Smart Switch Administration Guide

Setting Green Ethernet Properties for Ports

The Port Settings Page displays the current Green Ethernet Energy mode for
each port, and enables selecting a port for Green Ethernet Energy configuration
by using the Edit Port Setting Page. For the Green Ethernet modes to operate on a
port, the corresponding modes must be activated globally in the Properties Page.
To define per port Green Ethernet settings:
Click Port Management > Green Ethernet> Port Settings. The Port Settings
Page opens.
The Port Settings Page displays the following:
• Entry number—The sequential number of the entry in the table.
• Port—The port number.
• Energy Detect—State of the port regarding Energy Detect mode:
- Administrative—Displays whether Energy Detect mode was enabled.
- Operational—Displays whether Energy Detect mode is currently
operating.
- Reason—If Energy Detect mode is not operational, displays the reason.
• Short Reach—State of the port regarding Short Reach mode:
- Administrative—Displays whether Short Reach mode was enabled.
- Operational—Displays whether Short Reach mode is currently
operating.
- Reason—If Short-Reach mode is not operational, displays the reason.
The window displays the Short Reach setting for each port; however,
NOTE
the Short Reach feature is not enabled on any port unless the Short Reach
feature is also enabled globally by using the Properties Page. To enable
Short Reach globally, see the
section.
• Cable Length—Displays VCT cable length in meters.
Select a Port and click Edit. The Edit Port Setting Page opens.
Select to enable or disable Energy Detect mode on the port.
Select to enable or disable Short Reach mode on the port.
Setting Global Green Ethernet Properties
8
90