7.
Power on the system.
8.
Set the parameters on the master station using a programming tool.
Create a project on a programming tool.
Select "QCPU (Q mode)" under "Series". Select "Q20UDH" under "Type".
[Project]
[New]
9.
Open the "Network Parameter" window and check the checkbox next to "Set the station
information in the CC-Link configuration window.". (On GX Works2 only)
Project window
10.
Select 1 for "Number of Modules".
Set the field to 1.
[Parameter]
[Network Parameter]
CHAPTER 4 PROCEDURE BEFORE THE OPERATION
[CC-Link]
Check the checkbox.
4
65