Mitsubishi Electric MELSEC-Q Series User Manual page 103

(1) Operation Setting
Project window
button
Item
Set the name of the setting if needed.
Parameter Name This item is displayed when the setting details of the network
parameters are printed using a programming tool.
Select whether to clear or hold data input from a data link faulty
Data Link Faulty Station
Setting
station. (
Select whether to refresh or clear compulsorily output (sending) data
Case of CPU STOP
to a slave station when the switch on a CPU module is set to STOP.
Setting
(
Select whether or not to read the model name of slave stations with
the connected device auto-detection function.
Auto Detect Setting of
To read the model name of the slave stations with the connected
the Connected Device
device auto-detection function, refer to the following.
•
Number of Occupied
stations
The settings are not required when a master/local module is used as a
master station.
Expanded Cyclic
Setting
Select whether to assure the integrity of cyclic data for each slave
Block Data Assurance
per Station
station. (
[Parameter] [Network Parameter]
Description
Page 121, Section 7.5, Page 131, Section 8.2.3)
Page 121, Section 7.5, Page 133, Section 8.2.4)
iQ Sensor Solution Reference Manual
Page 150, Section 8.2.6 (1))
CHAPTER 7 PARAMETER SETTINGS
[CC-Link]
Setting range
Eight characters
• Clear input data (not checked)
• Hold input data (checked)
(Default: Clear input data (not
checked))
• Refresh (not checked)
• Clear compulsorily (checked)
(Default: Refresh (not checked))
• Do not to read the model name of the
slave stations (not checked)
• Read the model name of the slave
stations (checked)
(Default: Do not to read the model
name of the slave station (not checked)
–
• Disable setting (not checked)
• Enable setting (checked)
(Default: Disable setting (not checked))
7
101