Mitsubishi Electric MELSEC-Q Series User Manual page 220

6.
Write the PLC parameters and program to the CPU module. Then reset the CPU module or power
off and on the system.
7.
Set the switch on the CPU module in the master station to RUN to execute the program.
The G(P).RLPASET instruction is executed by executing the program, and the network parameters are
reflected to the master/local module.
• The network parameters are changed by turning on M500. (The error invalid station with station
number 2 and the reserved station with station number 3 are canceled.)
218
RESET
or power off on
RUN