Mitsubishi Electric MELSEC-Q Series User Manual page 247

• Initial setting for an AJ65VBTCU-68DAVN (station number 4)
Select "HEX".
Configuring the initial setting executes the following processes from the first condition.
Condition
1st The channels 1 and 2 are set to the analog output enable.
An output range is set.
2nd • Channel 1: 0 to 5V
• Channel 2: User range setting 1 (-10 to 10V)
The HOLD/CLEAR setting is configured.
3rd • Channel 1: CLEAR
• Channel 2: CLEAR
4th Initial data processing completion flag is turned on.
5th Initial data setting request flag is turned on.
6th Initial data processing completion flag is turned off.
7th Initial data setting request flag is turned off.
Remark
The initial setting of a remote device station can be also configured on a program. (
6.
Click the button to terminate the setting.
7.
Write the set parameters to the CPU module. Then reset the CPU module or power off and on the
system.
Data link is started.
[Online] [Write to PLC]
Description
RESET
or power off on
CHAPTER 10 PROGRAMMING
Page 252, Section 10.2.6)
245
10