Ip Filter Match Criteria - Alcatel-Lucent 7450 ESS Series Configuration Manual

IP(v4) Filter Match Criteria
dscp
Syntax
Context
Description
Default
Parameters
dst-ip
Syntax
Context
Description
Default
Parameters
Page 426
dscp dscp-name
no dscp
config>filter>ip-filter>entry>match
This command configures a DiffServ Code Point (DSCP) name to be used as an IP filter match
criterion.
The no form of the command removes the DSCP match criterion.
no dscp
dscp-name — Configure a dscp name that has been previously mapped to a value using the dscp-
name command. The DiffServ code point may only be specified by its name.
Values
be, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cs1, cp9, af11, cp11, af12, cp13, af13, cp15,
cs2, cp17, af21, cp19, af22, cp21, af23, cp23
dst-ip {ip-address[/mask]} [netmask
no dst-ip
config>filter>ip-filter>entry>match
This command configures a destination IP address range to be used as an IP filter match criterion.
To match on the destination IP address, specify the address and its associated mask, e.g. 10.1.0.0/16.
The conventional notation of 10.1.0.0 255.255.0.0 may also be used.
The no form of the command removes the destination IP address match criterion.
none
ip-prefix — The IP prefix for the IP match criterion in dotted decimal notation.
Values 0.0.0.0 — 255.255.255.255
ip-prefix-list — creates a list of IPv4 prefixes for match criteria in IPv4 ACL and CPM filter
policies.
ip-prefix-list-name — A string of up to 32 characters of printable ASCII characters. If special
characters are used, the string must be enclosed within double quotes.
mask — The subnet mask length expressed as a decimal integer.
Values
1 — 32
| ip-prefix-list prefix-list-name
7450 ESS OS Router Configuration Guide
]