Ip Filter Match Criteria - Alcatel-Lucent 7210 SAS E OS Configuration Manual

IP Filter Match Criteria

dscp
Syntax dscp dscp-name
no dscp
Context config>filter>ip-filter>entry>match
Description
This command configures a DiffServ Code Point (DSCP) name to be used as an IP filter match
criterion.
The no form of the command removes the DSCP match criterion.
Default no dscp
Parameters
dscp-name — Configure a dscp name that has been previously mapped to a value using the dscp-
dst-ip
Syntax dst-ip {ip-address[/mask]} [netmask]
no dst-ip
Context config>filter>ip-filter>entry>match
Description This command configures a destination IP address range to be used as an IP filter match criterion.
To match on the destination IP address, specify the address and its associated mask, e.g. 10.1.0.0/16.
The conventional notation of 10.1.0.0 255.255.0.0 may also be used.
The no form of the command removes the destination IP address match criterion.
Default
none
Parameters
ip-prefix — The IP prefix for the IP match criterion in dotted decimal notation.
mask — The subnet mask length expressed as a decimal integer.
netmask — Any mask epressed in dotted quad notation.
7210 SAS E Router Configuration Guide
name command. The DiffServ code point may only be specified by its name.
Values
be, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cs1, cp9, af11, cp11, af12, cp13, af13, cp15,
cs2, cp17, af21, cp19, af22, cp21, af23, cp23
Values
0.0.0.0 — 255.255.255.255
Values 0 — 32
Values
0.0.0.0 — 255.255.255.255
Filter Policies
Page 109