General Filter Entry Commands - Alcatel-Lucent 7450 ESS Series Configuration Manual

Carrier ethernet switch routers
Hide thumbs Also See for 7450 ESS Series:
Table of Contents

Advertisement

General Filter Entry Commands

entry
Syntax
entry entry-id [time-range time-range-name] [create]
no entry entry-id
Context
config>filter>dhcp-filter
config>filter>ip-filter
config>filter>ipv6-filter
config>filter>mac-filter
Description
This command creates or edits an IP (v4) or MAC filter entry. Multiple entries can be created using
unique entry-id numbers within the filter. Entries must be sequenced from most to least explicit.
An entry may not have any match criteria defined (in which case, everything matches) but must have
at least the keyword action for it to be considered complete. Entries without the action keyword will
be considered incomplete and hence will be rendered inactive.
The no form of the command removes the specified entry from the filter. Entries removed from the
filter are immidately removed from all services or network ports where that filter is applied.
Default
none
Parameters
entry-id — An entry-id uniquely identifies a match criteria and the corresponding action. It is
time-range time-range-name — Specifies the time range name to be associated with this filter entry
create — Keyword required when first creating the configuration context. Once the context is
log
Syntax
log log-id
no log
Context
config>filter>ip-filter>entry
config>filter>ipv6-filter>entry
config>filter>mac-filter>entry
Description
This command creates the context to enable filter logging for a filter entry and specifies the
destination filter log ID.
The filter log ID must exist before a filter entry can be enabled to use the filter log ID.
7450 ESS OS Router Configuration Guide
recommended that multiple entries be given entry-ids in staggered increments. This allows users
to insert a new entry in an existing policy without requiring renumbering of all the existing
entries.
Values
1 — 65535
up to 32 characters in length. The time-range name must already exist in the config>cron context.
created, one can navigate into the context without the create keyword.
Filter Policies
Page 417

Advertisement

Table of Contents
loading

Table of Contents