Global Filter Commands - Alcatel-Lucent 7450 ESS Series Configuration Manual

Global Filter Commands

dhcp-filter
Syntax
Context
Description
Parameters
ip-filter
Syntax
Context
Description
Parameters
Page 408
dhcp-filter filter-id [create]
no dhcp-filter filter-id
config>filter
This command configures the identification number of a DHCP filter.
filter-id — Specifies the DHCP filter policy ID number.
Values 1 — 65535
create — Keyword required when first creating the configuration context. Once the context is
created, one can navigate into the context without the create keyword.
[no] ip-filter filter-id [create]
config>filter
This command creates a configuration context for an IP (v4) filter policy.
The IP filter policy, sometimes referred to as an access control list (ACL), is a template that can be
applied to multiple services or multiple network ports as long as the scope of the policy is template.
Any changes made to the existing policy, using any of the sub-commands, will be applied
immediately to all services where this policy is applied. For this reason, when many changes are
required on an ip-filter policy, it is recommended that the policy be copied to a work area. That work-
in-progress policy can be modified until complete and then written over the original filter policy. Use
the config filter copy command to maintain policies in this manner.
The no form of the command deletes the IP filter policy. A filter policy cannot be deleted until it is
removed from all SAPs or network ports where it is applied.
filter-id — Specifies the IP filter policy ID number.
Values
1 — 65535
create — Keyword required when first creating the configuration context. Once the context is
created, one can navigate into the context without the create keyword.
7450 ESS OS Router Configuration Guide