Table of Contents
Advertisement
49-2570.fm Page 16 Wednesday, August 18, 1999 3:59 PM
5. Place one of the supplied num-
bered stickers on the sensor
transmitter to show its zone num-
ber.
6. Leave the console's switch set to
to install other accesso-
INSTALL
ries.
Repeat these steps for additional door/
window sensor transmitters.
INITIALIZING THE
MOTION DETECTOR
1. Press the four dots on the battery
compartment cover and slide the
cover down to remove it.
MOTION DETECTOR
2. Install four 1.5V AA alkaline bat-
teries (Cat. No. 23-552) inside the
motion detector's battery compart-
ment according to the polarity
symbols (+ and –) marked inside.
16
3. Be sure the console's
switch is set to
RUN 1/RUN 2
.
INSTALL
4. Press
on the back of the
TEST
motion
detector.
chimes, and the first available
zone indicator lights to show the
console has logged in the motion
detector.
TEST
If you do not hear a chime, press
with a pencil, then press
CODE
again.
TEST
5. Looking at the back of the motion
detector, set the switch on the left
side to
(see "Mounting the
1
Motion Detector").
1
2
6. Place one of the supplied num-
bered stickers on the motion
detector to show its zone number.
7. Leave the console's switch set to
to install other accesso-
INSTALL
ries.
8. Replace the motion detector's bat-
tery compartment cover.
INSTALL/
The
console
CODE
Advertisement
Table of Contents
