Trouble Alarm - Radio Shack CENTRAL 49-2570 Owner's Manual

49-2570.fm Page 24 Wednesday, August 18, 1999 3:59 PM
Notes:
• The supplied motion
(Cat. No. 49-2589) only operates
in the and
AWAY MIN
If you want to use the exit/entry
delay feature,
another motion detector (Cat. No.
61-2614) instead of the one sup-
plied with this system.
• You must set the switch inside the
door/window sensor transmitter's
battery compartment to
order for it to arm in the delay
mode. When set to
sor transmitter immediately arms,
regardless of whether the hand-
held remote control is set to
or
DELAY INSTANT
• The button on the console
ARM
automatically arms the system in
the mode.
DELAY
• The keychain remote control only
arms the system in the
mode.
• Other separately
remote controls might arm the
system only in either the
mode. See the remote
INSTANT
control's owner's manual.
• The system ignores sensor trans-
mitters operating in the
(such as the supplied motion
detector) during the entry delay.
24
detector
modes.
you can use
in
MAX
, the sen-
MIN
.
INSTANT
purchased
or
DELAY
mode
MIN

Trouble Alarm

If you hear a repetitive trouble alarm
when you try to arm the system, this in-
dicates that there is a problem.
The system does not arm until you:
• Correct the Problem — Press
to stop the trouble alarm.
DISARM
Check the zone reporting the
problem to see if a door or window
is open or a sensor transmitter's
battery is dead. Then arm the sys-
tem again.
• Ignore the Problem — Press
on the console while the
BYPASS
trouble alarm is sounding. The
problem zone's indicators flash
rapidly. Press
ARM HOME/ARM
to arm the system. The
AWAY
problem zone(s) are not pro-
tected, but all other zones arm.
PANIC
AWAY - ARM - HOME
BYPASS ZONES 9-16
ON - LIGHTS - OFF
plug'n power
C O M P A T I B L E
MONITOR AC POWER BATTERY LOW
Note: If you bypass an open window or
door, arm the system, and later close
the window or door, that zone arms.