Testing The System - Radio Shack CENTRAL 49-2570 Owner's Manual

49-2570.fm Page 18 Wednesday, August 18, 1999 3:59 PM

TESTING THE SYSTEM

After you complete the quick installa-
tion procedures, follow these steps to
test the system.
Note: To avoid alarming neighbors, tell
them you are testing the system.
1. Set
INSTALL/RUN 1/RUN 2
console to RUN 2.
2. Place each door/window sensor
transmitter's magnet next to its
magnetic switch.
WIRELESS SENSOR TRANSMITTER
3. Place the motion detector on a
counter top within 100 feet of the
console.
4. Move a door/window
transmitter's magnet away from
the magnetic switch.
When the system is not armed,
the console chimes every time
someone opens a door or window
with the system in the
mode. The system does not chime
in the RUN 1 mode.
Replace the magnet next to the
magnetic switch.
18
5. Press
and then move the magnet away
from the magnetic switch again.
The alarm sounds and the lamp
connected to the lamp module
flashes on and off. Press
to turn off the alarm, and
OFF
the magnet next to the magnetic
on the
switch.
6. Press
then walk across the path of the
motion detector's lens. The alarm
sounds and the lamp connected
to the lamp module flashes on and
off. Press
alarm. The console chimes twice.
Press
lamp.
sensor
RUN 2
on a remote control,
ARM
DISARM
LIGHTS
to turn off the lamp. Replace
on the remote control,
ARM
to turn off the
DISARM
to turn off the
LIGHTS OFF