Using Flash; Using Tone Services On A Pulse Line; Paging - Radio Shack ET-1125 Owner's Manual

Notes:
• You can also press
after pressing
TALK
number dialed.
• The redial memory holds up to 32
digits, so you can redial long-
distance as well as local numbers.
• The redial memory also holds pause
entries. See "Entering a Pause" on
Page 17.

USING FLASH

performs the electronic equiva-
FLASH
lent of a switchhook operation for spe-
cial services, such as Call Waiting.
For example, if you have Call Waiting,
press to answer an incoming call
FLASH
without disconnecting the current call.
Press again to return to the first
FLASH
call.
Note: If you do not have any special
phone services, pressing
disconnect the current call.
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse service, you can still use
these special tone services by following
these steps.
1. Be sure
DIAL MODE
(pulse).
2. Dial the service's main number.
3. When the service answers, press
REDIAL/PAUSE
to dial the last
The phone automatically resets to the
pulse mode the next time you make or
receive a call.

PAGING

To send a page from the base to the
handset or to locate the handset, when
the phone is not in use, press
FIND
for 5 seconds.
To locate the handset using a continu-
might
FLASH
ous beep, press and hold
longer than 2 seconds.
Press any key or place the handset on
the base to stop the page.
Note: The phone rings when a call
comes in while you are using the page
feature.
is set to
P
( ). Any additional numbers
TONE
you dial are sent as tone signals.
on the base. The handset beeps
PAGE/
PAGE/
FIND
PAGE/FIND
15