Related Manuals for Radio Shack ET-1112
Summary of Contents for Radio Shack ET-1112
-
Page 1: Cordless Phone
43-1112.fm Page 1 Monday, September 13, 1999 5:08 PM Cat. No. 43-1112 OWNER’S MANUAL Please read before using this equipment. ET-1112 900 MHz Digital Spread Spectrum Cordless Phone... - Page 2 20 numbers in memory for easy di- aling. Speed Dial — you can store three num- bers in the ET-1112’s speed dial memo- ry, then dial them with the touch of a button. Page — lets you send a signal from the...
-
Page 3: Read This Before Installation
AC power failure. • When AC power is lost, the ET-1112 loses the security access-protection code connection between the base and the handset. When power is... -
Page 4: Fcc Statement
43-1112.fm Page 4 Monday, September 13, 1999 5:08 PM FCC STATEMENT Your telephone complies with Part 68 of FCC Rules . Upon request, you must provide the phone’s FCC registration number and REN to your telephone company. These numbers are on the bottom of the base. -
Page 5: Installation
Caution: The supplied RadioShack AC adapter was designed specifically for your ET-1112. Use only the supplied adapter. On a Desk Top Follow these steps when you place the base on a desk, shelf, or table. - Page 6 Holder 7. Lift the base’s antenna to an upright position. Note: To mount the ET-1112 directly on a wall, you need two screws (not sup- plied) with heads that fit into the keyhole slots on the bottom of the base.
-
Page 7: Connecting And Charging The Battery Pack
43-1112.fm Page 7 Monday, September 13, 1999 5:08 PM CONNECTING AND CHARGING THE BATTERY PACK The phone comes with a rechargeable nickel-cadmium battery pack in the handset, but not connected. Before us- ing your phone, you must connect the battery pack and then charge it for about 24 hours. -
Page 8: Setting The Dialing Mode
43-1112.fm Page 8 Monday, September 13, 1999 5:08 PM • Using a pencil eraser, clean the charging contacts on the handset and the base about once a month. • If the TALK/BATT indicator does not light and the phone does not work, recharge the battery pack. -
Page 9: Setting The Ringer'stone And Volume
43-1112.fm Page 9 Monday, September 13, 1999 5:08 PM SETTING THE RINGER’S TONE AND VOLUME You can set four ringer tones and a high and low volume for each. To change the tone, lift the handset and press . Then, enter the ringer FLASH tone number (1–4) using the number keys. -
Page 10: Operation
TALK To answer a call, lift the handset if nec- essary then press TALK The ET-1112 scans 20 channels (fre- quency pairs used between the base and the handset) and automatically se- lects a clear channel each time you make or receive a call. -
Page 11: Using Flash
43-1112.fm Page 11 Monday, September 13, 1999 5:08 PM Press again to resume your MUTE phone conversation. USING FLASH performs the electronic equiva- FLASH lent of a switchhook operation for spe- cial services, such as Call Waiting. For example, if you have Call Waiting, press to answer an incoming call FLASH... -
Page 12: Memory Dialing
43-1112.fm Page 12 Monday, September 13, 1999 5:08 PM MEMORY DIALING The ET-1112 can store three telephone numbers in speed dial memory, and you can dial any one of these numbers by pressing a single button. You can also store up to 20 more numbers that you can dial by entering a two-digit memory location number. -
Page 13: Using A Headset
43-1112.fm Page 13 Monday, September 13, 1999 5:08 PM Entering a Pause In some telephone systems, you must dial an access code (9, for example) and wait for a second dial tone before you can dial an outside number. You can store the access code with the phone number. - Page 14 43-1112.fm Page 14 Monday, September 13, 1999 5:08 PM • If you place the handset on the base while the headset is connected, be sure the handset seats properly. With a headset connected, you can make or answer calls as usual using the keys on the handset.
-
Page 15: Troubleshooting
43-1112.fm Page 15 Monday, September 13, 1999 5:08 PM TROUBLESHOOTING We do not expect you to have any problems with your ET-1112, but if you do, the fol- lowing suggestions might help. Problem The phone does not work or works poorly. - Page 16 If you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the prob- lem, take your ET-1112 to your local RadioShack store for assistance. Suggestion Lift the base’s antenna to a fully upright position.
-
Page 17: Care And Maintenance
FCC authorization to operate it. If your ET-1112 is not performing as it should, take it to your local RadioShack store for assistance. If the trouble is affecting the telephone lines, the phone compa-... -
Page 18: Replacing The Battery Pack
43-1112.fm Page 18 Monday, September 13, 1999 5:08 PM REPLACING THE BATTERY PACK If you follow the instructions in “Connect- ing and Charging the Battery Pack” on Page 7, the battery pack should last about one year. If the battery pack does not hold a charge for more than 2 hours after an overnight charge, replace it with a new 3.6-volt, 600 mAh battery pack... - Page 19 Some cordless telephones operate on frequencies that might cause interfer- ence to nearby TVs and VCRs. To mini- mize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV or VCR. LIGHTNING...
- Page 20 43-1112.fm Page 20 Monday, September 13, 1999 5:08 PM Limited One-Year Warranty This product is warranted by RadioShack against manufacturing defects in material and workman- ship under normal use for one (1) year from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers.