Radio Shack ET-1125 Owner's Manual page 9

2. Lift the battery pack out of the com-
partment.
3. Plug the battery pack's connector in-
to the socket in the compartment,
(the connector fits only one way), re-
place the battery pack, and replace
the cover.
To charge the battery pack, place the
handset either faceup or facedown on
the base. The CHARGE/IN USE indica-
tor on the base lights and
appears on the handset display.
Recharge the battery pack when
Battery flashes on the display.
Note: If the CHARGE/IN USE indicator
flashes when the handset is on the
base, the battery pack is not connected
or loosely connected. Reconnect the
battery pack securely.
Notes:
• When you first use the phone after
charging or recharging the battery
pack, the phone might not work and
you might hear an error tone when
you press
to the base for about 5 seconds to
reset the security access-protection
code.
• If the handset or the base loses
power, the security access-protec-
tion code might be lost. To reset the
code, return the handset to the base
for about 5 seconds.
• Using a pencil eraser, clean the
charging contacts on the handset
and base about once a month.
Total:00
• If the battery pack becomes weak
during a call, the handset beeps ev-
ery 3 seconds and
flashes. When this happens, you
cannot make a call until you re-
Low
charge the battery pack.
• About once a month, fully discharge
the battery by keeping the handset
off the base until
flashes on the display. Otherwise,
the battery pack loses its ability to
fully recharge.
. Return the handset
TALK
Low Battery
Low Battery
9