Canon imagerunner C5180 Service Manual page 142

Chapter 5
YY Contents
#6 05 File system error
#7 05 File system error
#8 05 File system error
#9 00,01, Faulty HDD connection
02,04 or v x Works system
error
#10 11,21 Faulty HDD connection
or similar problem
#11 13,25 WriteAbort
#12 10,12, System error or packet
14 data error
22,23,
24
5-12
To prevent the mistaken erasure of information in this partition such as address
logs and filter data, HDD-CLEAR cannot be executed in Service Mode.
1. If possible, have the user pull up address log data by remote UI.
2. From Service Mode, enter Download Mode, perform a full format using SST,
reinstall the system (System, Lang, RUI), and turn the Main Power Switch OFF
and then ON again.
This error is not usually generated.
1. Execute HDD-CLEAR for CHK-TYPE = 1, 2, 3, 5, and then turn the power OFF
and then ON again.
2. If the above does not correct the problem, the HDD may be assumed to be
damaged, so replace the HDD and reinstall the system.
Repair operations in the boot partition can only be performed when using SST in
Safe Mode.
1. Start the system in Safe Mode, perform a full format using SST, reinstall the
system (System, Lang, RUI), and turn the Main Power Switch OFF and then ON
again.
2. If the above does not correct the problem, the HDD may be assumed to be
damaged, so replace the HDD and reinstall the system.
1. 0Check cables and connectors.
2. If the above does not correct the problem, start the system in Safe Mode,
perform a full format using SST, reinstall the system (System, Lang, RUI), and
turn the Main Power Switch OFF and then ON again.
3. If the above still does not correct the problem, the HDD may be assumed to be
damaged, so replace the HDD and reinstall the system.
This error is not usually generated at the read/write level.
1. Check cables and connectors.
2. If the above does not correct the problem, the HDD may be assumed to be
damaged, so replace the HDD and reinstall the system.
There is a high likelihood that document data such as BOX on the HDD is
damaged.
1. Enter the CHK-TYPE for the partition, execute HDD-CHECK (may take
anywhere from several minutes to several tens of minutes), and then turn the power
OFF and then ON again.
2. If the above does not restore the system, enter CHK-TYPE for the partition,
execute HDD-CLEAR, and turn the Main Power Switch OFF and then ON again.
(For the BOOTDEV, BOOTDEV2, and APL_SEND partitions, reformat and
reinstall using SST.)
3. If the above still does not correct the problem, the HDD may be assumed to be
damaged, so replace the HDD and reinstall the system.
This error is generated due to invalid data or software bug.
1. Start the system in Safe Mode, perform a full format using SST, reinstall the
system (System, Lang, RUI), and turn the Main Power Switch OFF and then ON
again.
2. If the above does not correct the problem, the HDD may be assumed to be
damaged, so replace the HDD and reinstall the system.
Remedy