Table of Contents
Advertisement
43-1098.fm Page 15 Tuesday, August 17, 1999 4:03 PM
Switching Between the
Handset and Speakerphone
To switch from the handset to the
speakerphone at any time during a call,
press
on the handset, then
HOLD
on the base so its red indica-
SPEAKER
tor turns on, and begin the conversation.
illus of handset HOLD location
To switch from the speakerphone to the
handset, lift the handset off the base. If
the handset is already off the base,
press
on the base. The red
HOLD
SPEAKER indicator flashes. Then press
on the handset to release the
HOLD
hold.
ADJUSTING THE VOLUME
The handset's
VOLUME
set the volume you hear through the
handset to one of four levels. The base's
control lets you set the volume
VOLUME
of the speakerphone to one of eight lev-
els.
illus of base VOLUME
To turn the volume up or down during a
call, repeatedly press
the handset or base. The ET-928 beeps
once each time you press
t. When you reach the highest or lowest
volume level, the ET-928 beeps three
times.
USING REDIAL
To redial the last number dialed, press
REDIAL
you hear the dial tone.
control lets you
illus of base VOLUME
VOLUME
VOLUME
on the handset or base when
illus of handset/base
REDIAL locations
s or t on
s or
15
Advertisement
Table of Contents
