Table of Contents
Advertisement
43-1098.fm Page 18 Tuesday, August 17, 1999 4:03 PM
SPECIAL FEATURES
MEMORY DIALING
You can store up to 20 numbers of up to
16 digits each in the ET-928's memory,
then dial them with the press of a few
buttons.
Storing a Number
Notes:
• You can use either the base or the
handset to store and dial numbers.
• You must complete these steps
within 30 seconds of each other. If
you do not, the ET-928 sounds a
long beep, all indicators stop flash-
ing, and you must start over again at
Step 1.
• You can store special banking or
telephone service numbers (such as
access codes or account numbers)
in memory, but for security pur-
poses, we recommend that you do
not store private numbers (such as
personal identification numbers or
passwords) in memory.
1. Press
memory
MEM (
set or base. The TALK indicator on
the handset and the SPEAKER indi-
cator on the base flash.
illus of base MEM
location
18
2. Enter the number you want to store.
3. Press
Notes:
• To change a number in memory,
• To erase a number from memory,
on the hand-
)
Notes:
• If you have pulse service and
want to send tone signals, press
at the appropriate place
TONE
in the sequence of numbers.
• Each
or pause entry
TONE
(see "Storing a Pause" on Page
19) counts as one digit in mem-
ory.
then the number key
MEM
(
–
) of the memory location
01
20
where you want to store the number.
The phone beeps twice and stores
the number, and all indicators turn
off.
store a new one in its place.
repeat Steps 1 and 3, skipping Step
2.
Advertisement
Table of Contents
