Table of Contents
Advertisement
43-1098.fm Page 12 Tuesday, August 17, 1999 4:03 PM
• If the battery pack becomes weak,
the handset sounds a short beep
every 16 seconds during a call (or
every 64 seconds when the handset
is not in use) and the BATT LOW
indicator flashes. Within about 10
minutes, the phone will automati-
cally disconnect. Recharge the bat-
tery pack.
• If the battery pack loses its charge
completely or the base loses power
while the handset is away from it,
the security access-protection code
needs to be reset. To reset the secu-
rity code, place the handset on the
base. If it was the handset that lost
power, leave the handset on the
base to charge the battery pack.
• About once a month, fully discharge
the battery pack by keeping the
handset off the base until the BATT
LOW indicator turns on. Otherwise,
it loses its ability to fully recharge,
and you might have to recharge and
replace it more often.
SETTING THE DIALING
MODE
Set
(Tone/Pulse
for the type of ser-
T/P
)
vice you have. If you are not sure which
type you have, do this test.
1. Set
T/P
on the back of the base to
illus -- reduce to fit
space
12
2. Press
SPEAKER
the base (or
after the battery is charged) and lis-
ten for a dial tone.
illus -- (1) SPEAKER on base
and (2) TALK on handset (show
more of base)
3. Press any number other than
Note: If your phone system requires
that you dial an access code (
example) before you dial an outside
number, do not press the access
code either.
If the dial tone stops, you have
touch-tone service. Leave
.
T
If the tone continues, you have
pulse (rotary) service. Set
4. To hang up, press
base (or
TALK
either LED indicator turns off.
ADJUSTING THE
RINGERS
The ET-928's handset and base each
T
.
have four different ringer tones. You can
set the base's and handset's ringer tone,
or turn off the ringer on either or both.
(speakerphone) on
TALK
on the handset
.
0
, for
9
set to
T/P
to
.
T/P
P
on the
SPEAKER
on the handset) so
Advertisement
Table of Contents
