Olivetti DP-670 Service Manual page 61

Maintenance
item No.
Checking DP operation
U203
Description
Simulates the original conveying operation separately in the DP.
Purpose
To check the DP operation.
Method
1. Press the start key.
2. Place an original in the DP if running this simulation with paper.
3. Select the item to be operated.
Display
CCD ADP
(NON P)
CCD ADP
CCD RADP
(NON P)
CCD RADP
SPEED
4. Press the start key. The operation starts.
5. To stop continuous operation, press the stop key.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Checking the operation of the DP motors
U243
Description
Turns the motors or solenoids in the DP on.
Purpose
To check the operation of the DP motors and solenoids.
Method
1. Press the start key.
2. Select the item to be operated.
3. Press the start key. The operation starts.
Display
DP FEED MOT
DP CON MOT
DP REV MOT
DP RP SOL
DP RJ SOL
4. To turn each motor off, press the stop key.
Completion
Press the stop key when operation stops. The screen for selecting a maintenance item No. is displayed.
Y108671-9
Description
Description
Without paper, single-sided original
(continuous operation)
With paper, single-sided original
Without paper, double-sided original
(continuous operation)
With paper, double-sided original
Switching between normal reading (600 dpi)
and high-speed reading
Motor and solenoid
Original feed motor (OFM)
Original conveying motor (OCM)
Original switchback motor (OSBM)
Switchback pressure solenoid (SBPSOL)
Switchback feedshift solenoid (SBFSSOL)
Service Manual
Setting range Initial setting
- -
- -
- -
- -
0 (Normal)/
0
1 (High-speed)
Operation
In operation
In operation
In operation
On for 0.5 s
On for 0.5 s
3K5-2
1-3-41