Olivetti DP-670 Service Manual page 30

3K5
Maintenance
item No.
Checking DP operation
U203
Description
Simulates the original conveying operation separately in the DP.
Purpose
To check the DP operation.
Method
1. Press the start key.
2. Place an original in the DP if running this simulation with paper.
3. Select the item to be operated.
4. When selecting [ADP] or [RADP], to set the magnification using the +/- keys.
Display
ADP
RADP
ADP (NON P)
RADP (NON P)
SPEED
5. Press the start key. The operation starts.
6. To stop continuous operation, press the stop key.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Checking the operation of the DP motors
U243
Description
Turns the motors and solenoids in the DP on.
Purpose
To check the operation of the DP motors or solenoids.
Method
1. Press the start key.
2. Select the item to be operated.
3. Press the start key. The operation starts.
Display
DP FEED MOTOR
DP CONV MOTOR
DP REV MOTOR
DP RJ SOL
DP RP SOL
4. To stop operation, press the stop key.
Completion
Press the stop key when operation stops. The screen for selecting a maintenance item No. is displayed.
1-3-10
Description
Operation
With paper, single-sided original
With paper, double-sided original
Without paper, single-sided original
(continuous operation)
Without paper, double-sided original
(continuous operation)
Switching between normal reading (600
dpi) and high-speed reading
Motors and solenoids
Original feed motor (OFM) is turned on.
Original conveying motor (OCM) is turned on.
Original switchback motor (OSBM) is turned on.
Switchback feedshift solenoid (SBFSSOL) is turned on.
Switchback pressure solenoid (SBPSOL) is turned on.
Service Manual
Setting range Initial setting
100 to 200 (%) 100
100 to 200 (%) 100
- -
- -
0 (Normal)/ 0
1 (high-speed)
Y108671-9