Olivetti DP-670 Service Manual page 51

Maintenance
item No.
Checking counts by optional devices
U905
Description
Displays the counts of DP or finisher.
Purpose
To check the use of DP and finisher.
Method
1. Press the start key.
2. Select the device, the count of which is to be checked. The count of the selected device is displayed.
Display
DP
FINISHER
DP
Display
ADP
RADP
Finisher
Display
CP CNT
STAPLE
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Setting of deflection for feeding from DP
U942
Description
Adjusts the deflection generated when the DP is used.
Purpose
Use this mode if an original non-feed jam, oblique feed or wrinkling of original occurs when the DP is used.
Setting
1. Press the start key.
2. Select the item to be adjusted.
Display
FEED MOT
REV MOT
3. Press the interrupt key.
4. Place an original on the DP and press the start key to make a test copy.
5. Press the interrupt key.
6. Change the setting value using the cursor up/down keys.
The greater the value, the larger the deflection; the smaller the value, the smaller the deflection.
If an original non-feed jam or oblique feed occurs, increase the setting value. If wrinkling of original
occurs, decrease the value.
7. Press the start key. The setting is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Y108671-9
Description
Counts of optional DP
Counts of optional finisher
Description
No. of single-sided originals that has passed through the DP
No. of double-sided originals that has passed through the DP
Description
No. of copies that has passed
Frequency the stapler has been activated
Description
Deflection in the original feed motor
Deflection in the original switchback
motor
Service Manual
Description
Setting
range
-31 to 31
-31 to 31
Initial Change in
setting value per step
0 0.098 mm
0 0.098 mm
1-3-31
3K5