Duplex Mode Setting; Led Indication - Planet FT-802/S Manual

6. Duplex Mode setting

The TP port of FT-80X support duplex mode detection by
auto-negotiation (A-N). The following is the duplex mode
parameters:
Fast Ethernet Device
Ethernet / Fast Ethernet Hub
Ethernet / Fast Ethernet Switch (without A-N)
Fast Ethernet Devices *
Support Auto-Negotiation
Note: Normally, an A-N switch will detect and set to
full-duplex, where a dual-speed hub will detects Half.
There is a DIP-switch as in the left view above. Please check
and follow the duplex mode of the fiber device and have the
duplex selection to your FT-80X.

7.LED indication

LED COLOR
FX Link Green Blinks when any FX packets transmitting
/ACT
Lit when Fiber connection is good
Blinks when any FX packets receiving
TP Link/ Green Blinks when any TP packets transmitting
ACT
Lit when TP connection is good
Blinks when any TP packets receiving
FDX/COL Green Lit when Full-duplex mode is enabled in
* FX port and blink shows collision detected.
100 Green Lit when the port runs in 100Mbps.
Remains off while LINK LED lit represent
FT-80X Duplex
Mode support
Half-Duplex
Half-Duplex
Full-Duplex /
Half-Duplex
DESCRIPTION
4