Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Planet FT-807
Summary of Contents for Planet FT-807
- Page 1 10/100Base-TX to 100Base-FX SMI Fast Ethernet Converter FT-807 User’s Manual...
-
Page 2: Fcc Warning
PLANET. PLANET assumes no responsibility for any inaccuracies that may be contained in this User’s Manual. PLANET makes no commitment to update or keep current the information in this User’s Manual, and reserves the right to make improvements to this User’s Manual and/or to the products described in this User’s Manual, at any time without... - Page 3 Revision PLANET Fast Ethernet Converter User’s Manual FOR MODEL: FT-807 Rev: 1.1(December, 2005) Part No. 2010-AA3330-001...
-
Page 4: Table Of Contents
Table of Content Chapter 1 Introduction ..............5 1.1 Product Description ............5 1.2 Packet Contents ............... 5 1.3 Technical Specification ............. 5 1.4 Product Outlook..............6 1.5 Duplex Mode Setting ............6 1.6 Power information ............7 Chapter 2 Installation ..............8 Appendix A: RJ-45 pin assignment and cable system.... -
Page 5: Chapter 1 Introduction
Chapter 1 Introduction The PLANET FT-807 is a 10/100Base-TX shielded twisted pair (STP) to Fast Ethernet 100Base-FX fiber converter. It supports full-duplex operations at its fiber-optic interface in the form factor of SMI (Small Multimedia Interface) interface. The converter auto-adapts to the highest level of performance supported by the device connected to the STP port. -
Page 6: Product Outlook
TP: Lights to indicate the TP connection is established. PWR: Lights to indicate the converter is powered. 1.5 Duplex Mode Setting The TP port of FT-807 supports duplex mode detection by auto-negotiation (A-N). The following is the duplex mode parameters: Fast Ethernet Device... -
Page 7: Power Information
Normally, an A-N switch will detect and set to full-duplex, where a dual-speed hub will detects half. The fiber port (POF) port of FT-807 is fixed at 100Mbps full-duplex mode. The link partner should also set at 100Mbps full-duplex mode at the same time. -
Page 8: Chapter 2 Installation
Chapter 2 Installation Please follow these steps to install the converter: Turn off the power of the device/station in a network to which the FT-807 will be 。 attached. 。 Ensure that there is no activity in the network. 。... -
Page 9: Appendix A: Rj-45 Pin Assignment And Cable System
When connecting 10/100Mbps TP port to other devices, a straight or crossover cable is necessary. The TP port of FT-807 supports auto-MDI detection. That means you can directly connect the TP port to any Ethernet devices without making a crossover cable. -
Page 10: 100Mbps, 100Base-Fx, Smi Type Connector
A.2 100Mbps, 100Base-FX, SMI type connector FT-807 is using POF SMI type connector that is mostly being used for IEEE1394b transmission. The followings show the basic information. The POF Cable should be a dual wire cable with 0.98mm optic core with cladding diameter 1mm.