Showing Module Configurations; Show Module Command; Show Port Command - 3Com CoreBuilder 5000 User Manual

4-6 C
ONFIGURING THE
Showing Module
Configurations
Show Module
Command

Show Port Command

M
ODULE
You can display status information about the 12-Port 100BASE-TX
Workgroup FastModule using the following network management
commands:
SHOW MODULE
SHOW PORT
This command enables users to display both brief and verbose
information about a particular module.
Use the following command to display module information:
SHOW MODULE{ slot. 1}
The following output is an example of the SHOW MODULE VERBOSE
command issued for a 12-Port 100BASE-TX Workgroup FastModule
installed in slot 10:
CB5000> show module 10.1 verbose
Slot Module Version Network General Information
--------------------------------------------
10.01 6512M-TX'v1.00 FAST_ETHER_1 Port(s) are down
6512M-TX: FastModule 100BASE-TX 12Port Shared Fast Ethernet
Boot Version:
Network DIP Setting:
Non-Volatile DIP Setting:
This command enables users to display brief and verbose information
on both individual ports and all ports collectively.
Use the following command to display port information:
SHOW PORT { slot.port } {verbose}
{ slot. all}
{verbose}
{no_verbose}
v1.00
FAST_ETHER_1
DISABLED
{no_verbose}