Gathering Repeater Statistics; Statistics-Gathering Process - 3Com CoreBuilder 5000 User Manual

Gathering
Repeater Statistics
Statistics-Gathering
Process
The following output is an example of the SHOW PORT VERBOSE
command issued for port 2 on a 12-Port 100BASE-TX Workgroup
FastModule installed in slot 10:
CB5000> show port 10.2 verbose
Port Display for Module 6512M-TX:
Port Mode Status
----- -------- ---------- ---------------- -------------
10.02 ENABLED OKAY
Alert Filter:
Port Connector:
This section describes how the 12-Port 100BASE-TX Workgroup
FastModule:
Gathers repeater statistics
Monitors network statistics
The 12-Port 100BASE-TX Workgroup FastModule gathers repeater
statistics for each port (for example, collision, partition, late events,
data rate mismatch, and short event statistics). This module gathers
repeater statistics without the use of a network monitor card.
Repeater statistics are gathered from traffic only entering through the
front panel ports on the 100BASE-TX Workgroup FastModule. The only
statistics counted are those received on the front panel ports.
The repeater statistics that are available include:
Network – Network statistics are presented by gathering events
from all ports on the 12-Port 100BASE-TX Workgroup FastModules
specified on the network. Network statistics are the total amount of
all of the module statistics together.
Module – Module statistics represent the total events from traffic
entering on all ports on a specified module.
Port – Per-port statistics are a count of events from traffic entering
the specified port.

Gathering Repeater Statistics

Network General Information
FAST_ETHER_1
DISABLED
RJ-45
4-7