1-4
I
NTRODUCTION
Managing
100BASE-TX
Workgroup
FastModules
Determining Model
Number
To access in-band management in a hub with all 100BASE-TX
Workgroup FastModules, you must have another type of FastModule,
SwitchModule, or 10BASE-T Ethernet module and network monitor
card installed.
You can manage CoreBuilder 5000 100BASE-TX Workgroup
FastModules using the DMM command line interface.
The DMM supports:
In-band management using SNMP (Simple Network Management
Protocol) or TELNET
Out-of-band management using SLIP (Serial Line Interface Protocol)
for TELNET and SNMP
You must use DMM software Version v4.1 or later to manage and
configure the 12-Port 100BASE-TX Workgroup FastModules.
You need to determine your model number to:
Be able to perform configurations effectively
Identify your product for product orders or customer support
Make certain you have the correct model number
The model number on 100BASE-TX Workgroup FastModule faceplate
may differ slightly from the model number registered in the DMM or
Advanced DMM software. To determine your FastModule model
number for product orders or customer support:
1 Use the model number registered in the DMM or Advanced DMM
software (to determine your software version).
2 Add the prefix 3C9 to the model number.
For example, use the number 3C96512M-TX for Model
Number 6512M-TX.
To determine the 100BASE-TX Workgroup FastModule model number,
enter the command SHOW MODULE ALL at the DMM prompt and use
the model number listed in the Module field.