Configuring The; Module; Configuring The Module - 3Com CoreBuilder 5000 User Manual

4

Configuring the

Module

C
ONFIGURING THE
This chapter describes how to configure the 3Com
™
CoreBuilder 5000 12-Port 100BASE-TX Workgroup FastModule.
A quick start and reference guide for the 12-Port 100BASE-TX
Workgroup FastModule lists the LED indicators and other module
information.
This chapter contains the following sections:

Configuring the Module

Showing Module Configurations
Gathering Repeater Statistics
Monitoring the Front Panel
Verifying LED and Network Operation
This section describes how to configure the module using network
management commands. The following network management
commands are used to configure the 12-Port 100BASE-TX Workgroup
FastModule:
Set port mode commands
Set port alert filter command
Select the Fast Ethernet network on the module
For additional information on network management commands, refer
to the CoreBuilder 5000 Distributed Management Module Commands
Guide.
M
ODULE