Wall-Mount Installation - AT&T EL51200 User Manual

Dect 6.0 cordless telephone with caller id/call waiting

Hide thumbs Also See for EL51200:

Table of Contents

Getting started

Wall-mount installation

The telephone base comes ready for tabletop use (see Telephone base and

charger installation on page 6). If you want to mount your telephone on a

wall, use the provided wall-mount bracket to connect with a standard dual-

stud telephone wall-mounting plate. If you do not have this mounting plate,

you can purchase one from many hardware or consumer electronics retailers.

Professional assistance may be required to install the mounting plate.

Tabletop to wall-mount installation

To install the telephone base in the wall-mount position, make sure you first

unplug the power adapter from the electrical outlet and unplug the telephone

line cord from the wall outlet.

Plug one end of the telephone line cord into the TEL LINE jack on the

bottom of the telephone base. Plug the small end of the base power adapter

into the POWER jack on the bottom of the telephone base.

Position the telephone base as shown below. Insert the extended tabs of the

wall-mount bracket into the slots on the back of the telephone base. Push

the telephone base down until it clicks securely in place.

Route the telephone line cord through the wall-mount bracket hole. Route

the power cord out of the bottom of the telephone.

Slots for wall-mount

bracket installation

DSL filter (not included)

required if you have DSL high-

speed Internet service.

Table of Contents