Install; Telephone Base; Wall-Mount Installation (Optional) - AT&T EL52103 Quick Start Manual

Install

Battery
Install the battery, as shown below.
Charge your handset(s) before initial use. The battery is fully charged after 16
hours of continuous charging. The CHARGE light on the top of the handset is on
during charging.
CHARGE light
Caution: Use only the supplied rechargeable battery or replacement battery
(model BT162342/BT262342).
6

Wall-mount installation (optional)

Plug the telephone line into
1
the telephone base.
A DSL filter (not included)
is required if you have DSL
high-speed Internet service.
Align the holes on the wall-
3
mount bracket with the
standard wall plate.
A DSL filter (not included) is
required if you have DSL
high-speed Internet service.
Insert the extended tabs of the
2
wall-mount bracket into the slots
on the back of the telephone
base. Push the telephone base
down until it is securely in place.
Slide the wall-mount bracket
4
down until it locks securely.
Plug the power adapter into a
power outlet not controlled by
a wall switch. Plug the other end
of the power adapter into the

telephone base.

DSL filter
7