Siemens SINUMERIK 840D sl Operating Manual page 39

Overview of display
Display
Header columns
Work/Machine
Position
Display of distance-to-go
Feed/override
Repos offset
Collision monitoring
(only 840D sl)
Footer
See also
Overview (Page 78)
Zero offsets (Page 113)
Milling
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Meaning
Display of axes in selected coordinate system.
Position of displayed axes.
The distance-to-go for the current NC block is displayed while the
program is running.
The feed acting on the axes, as well as the override, are displayed
in the full-screen version.
The distances traversed in manual mode are displayed.
This information is only displayed when you are in the "Repos"
submode.
The collision avoidance is switched on for the JOG and
MDI or AUTOMATIC modes and at least one active
collision pair is present.
The collision avoidance is switched off for the JOG and
MDI or AUTOMATIC modes or no active collision pair is
present.
Display of active work offsets and transformations.
The T, F, S values are also displayed in the full-screen version.
Introduction
1.4 User interface
39