How To Enter Dtb Service Menu - Pioneer PDP-5020FD Service Manual

5
Ethernet
Can network functions be used
with the PC (server) without any
problem?
Yes
Is the Link LED of the Ethernet
terminal on the server side lit?
Yes
Is the MAC Address [00:e0:36:**:**:**]
displayed on the network Setup
screen?
Yes
Is the HMG Setup correctly set?
Yes
Can the server be selected (not
grayed out) from the PDP?
Yes
Are the properties of the files
displayed on the Factory screen?
Yes
Defective decoding section of the
BCM7404.
Replace the MAIN Assy.
[HMG] How to enter DTB Service menu
Note: Use the remote control unit that supports Factory mode, because the DTB Service menu is accessible from Factory mode.
Step 1: Press the Factory key on the remote control unit to display the INFORMATION screen of Factory mode.
Step 2: Press the Mute key on the remote control unit 3 times to display the INITIALIZE screen.
Step 3: Press the j key on the remote control unit twice to display the "DTB SERVICE MODE (+)" indication at the bottom of the screen.
Step 4: Press the ENTER/SET key on the remote control unit to display the "MODE SHIFT <=>: No" indication at the bottom of the screen.
Step 5: Press the k or l key on the remote control unit until the "MODE SHIFT <=>: YES" indication is displayed at the bottom of the screen.
Step 6: Press and hold the ENTER/SET key on the remote control unit pressed for 5 seconds or more to activate DTB Service menu.
The Home Media Gallery (HMG) Service menu is indicated below:
Top page of DTB Service menu
5
6
No
Defective network board of the PC.
No
Is the cable OK?
Yes
Defective Ethernet section on the
MAIN Assy
No
The data specific to the MAIN
Assy have been deleted.
No
Improper HMG Setup.
No
Is the PC recognized by the server
as a device?
Yes
Can the files on the server be
recognized?
Yes
Defective decoding section of the
BCM7404.
No Defective Ethernet section of the
BCM7404.
Home Media Gallery Service menu
PDP-5020FD
6
7
No
Problem with the cable.
Replace the MAIN Assy.
No
Replace the MAIN Assy.
No Check the settings of the server
again.
Check the settings of the shared
folder for the server again.
Replace the MAIN Assy.
No
Replace the MAIN Assy.
7
8
A
B
C
D
E
Content data
Ethernet connection data
F
USB device data
67
8