Pdp Service Remote Control - Pioneer PDP-5020FD Service Manual

1
A

[5] PDP SERVICE REMOTE CONTROL

• The keys labeled with the same names on the service remote control unit have the same functions as those of the supplied
remote control unit. (See "2.3 PANEL FACILITIES.")
• For the keys not provided on the supplied remote control unit, see the explanations below:
B
C
INTEGRATOR
Press this key to enter Integrator mode.
D
SUB INPUT
Not used with this model.
DRIVE OFF
Press this key to turn off the panel drive.
For details on how to cancel this command,
see the explanation for the DRV command.
AUTO SETUP
Use this key for automatic setup, such as
the display position setting when an analog
PC signal is input.
ID NO. SET
E
Not used with this model.
POINT ZOOM
Not used with this model.
ZOOM +/-
Not used with this model.
F
114
1
2
PDP-5020FD
2
3
GENERATION switch for remote control codes
This switch selects the generation of remote control
codes to be transmitted:
1: The old-generation codes are transmitted.
2: The new-generation codes are transmitted.
With this generation plasma display,
set the switch to 2.
INPUT
Press this key to cyclically change the input source.
EXT INPUT
Press this key to cyclically change only the
external input source.
FACTORY
Press this key to enter Factory mode.
2nd FACTORY
Not used with this model.
POWER CONTROL
Not used with this model.
CLEAR
Not used with this model.
POWER ON
Press this key to turn on the unit.
This key cannot turn the unit off.
POWER OFF
Press this key to turn off the unit.
This key cannot turn the unit on.
3
4
4