Dell PowerConnect J-EX4200-24T Software Manual page 974

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Step-by-Step
Procedure
Results
Verification
Purpose
Action
902
To configure unicast RPF on Switch A:
Enable unicast RPF on interface
1.
[edit interfaces]
user@switch# set ge-1/0/10 unit 0 family inet rpf-check
Check the results:
[edit interfaces]
user@switch# show
ge-1/0/10 {
unit 0 {
family inet {
rpf-check;
}
}
}
To confirm that the configuration is correct, perform these tasks:
Verifying That Unicast RPF Is Enabled on the Switch on page 902
Verifying That Unicast RPF Is Enabled on the Switch
Verify that unicast RPF is enabled.
Verify that unicast RPF is enabled on interface
or
ge-1/0/10 extensive show interfaces ge-1/0/10 detail
user@switch> show interfaces ge-1/0/10 extensive
Physical interface: ge-1/0/10, Enabled, Physical link is Down
Interface index: 139, SNMP ifIndex: 58, Generation: 140
Link-level type: Ethernet, MTU: 1514, Speed: Auto, MAC-REWRITE Error: None,
Loopback: Disabled, Source filtering: Disabled, Flow control: Enabled,
Auto-negotiation: Enabled, Remote fault: Online
Device flags : Present Running
Interface flags: Hardware-Down SNMP-Traps Internal: 0x0
Link flags : None
CoS queues : 8 supported, 8 maximum usable queues
Hold-times : Up 0 ms, Down 0 ms
Current address: 00:19:e2:50:95:ab, Hardware address: 00:19:e2:50:95:ab
Last flapped : Never
Statistics last cleared: Never
Traffic statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
IPv6 transit statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
Input errors:
Errors: 0, Drops: 0, Framing errors: 0, Runts: 0, Policed discards: 0,
:
ge-1/0/10
by using the
ge-1/0/10
command.
0
0
0
0
0
0
0
0
show interfaces
0 bps
0 bps
0 pps
0 pps