After A Fuse Is Replaced; If There Is An Overload In A Circuit - Toyota Land Cruiser Prado Owner's Manual

4-3. Do-it-yourself maintenance
■

After a fuse is replaced

●
If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. (→P. 517)
●
If the replaced fuse blows again, have the vehicle inspected by your
Toyota dealer.
■

If there is an overload in a circuit

The fuses are designed to blow, protecting the wiring harness from damage.
CAUTION
■
To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failure to do so may cause damage to the vehicle, and possibly a fire or
injury.
●
Never use a fuse of a higher amperage rating than indicated, or use any
other object in place of a fuse.
●
Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
●
Do not modify the fuses or fuse boxes.
NOTICE
■
Before replacing fuses
Have the cause of electrical overload determined and repaired by your
Toyota dealer as soon as possible.
516