4
Check if the fuse is blown.
1
Normal fuse
2
Blown fuse
Replace the blown fuse with a new fuse of an appropriate amperage rat-
ing. The amperage rating can be found on the fuse box lid.
Type A
After a fuse is replaced
■
If the lights do not turn on even after the fuse has been replaced, a bulb may
●
need replacement. (→P. 281)
If the replaced fuse blows again, have the vehicle inspected by your Toyota
●
dealer.
If there is an overload in a circuit
■
The fuses are designed to blow, protecting the wiring harness from damage.
When replacing light bulbs
■
Toyota recommends that you use genuine Toyota products designed for this
vehicle. Because certain bulbs are connected to circuits designed to prevent
overload, non-genuine parts or parts not designed for this vehicle may be
unusable.
When installing the glove box
■
Ensure that the claw is completely fit. Then, close the box. If the lower claw is
not completely engaged, the box will not open.
RUSH_OM_General_OMBZ265
6-3. Do-it-yourself maintenance
Type B
KBTE731003
279
KBTE731004
6