Toyota Land Cruiser Prado Owner's Manual page 602

Start the engine of the second vehicle. Increase the engine
STEP 3
speed slightly and maintain at that level for approximately 5
minutes to recharge the battery of your vehicle.
Vehicles with a smart entry & start system: Open and close
STEP 4
any of the doors with the "ENGINE START STOP" switch
off.
Maintain the engine speed of the second vehicle and start
STEP 5
the engine of your vehicle by turning the "ENGINE START
STOP" switch to IGNITION ON mode (vehicles with a smart
entry & start system) or turning the engine switch to the
"ON" position (vehicles without a smart entry & start sys-
tem).
Once the vehicle's engine has started, remove the jumper
STEP 6
cables in the exact reverse order in which they were con-
nected.
Vehicles with 1GR-FE engine only: To install the engine
STEP 7
cover, conduct the removal procedure in reverse. After
installing, check that the fixed pins are inserted securely.
Once the engine starts, have the vehicle checked at your Toyota
dealer as soon as possible.
5-2. Steps to take in an emergency
5
601